Datasheet

Section 16 A/D Converter (8 Analog Input Channel Version)
Rev.6.00 Sep. 27, 2007 Page 705 of 1268
REJ09B0220-0600
16.2 Register Descriptions
16.2.1 A/D Data Registers A to D (ADDRA to ADDRD)
Bit : 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
AD9 AD8 AD7 AD6 AD5 AD4 AD3 AD2 AD1 AD0 — — — — — —
Initial value : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
R/W : R R R R R R R R R R R R R R R R
There are four 16-bit read-only ADDR registers, ADDRA to ADDRD, used to store the results of
A/D conversion.
The 10-bit data resulting from A/D conversion is transferred to the ADDR register for the selected
channel and stored there. The upper 8 bits of the converted data are transferred to the upper byte
(bits 15 to 8) of ADDR, and the lower 2 bits are transferred to the lower byte (bits 7 and 6) and
stored. Bits 5 to 0 are always read as 0.
The correspondence between the analog input channels and ADDR registers is shown in table
16.3.
The ADDR registers can always be read by the CPU. The upper byte can be read directly, but for
the lower byte, data transfer is performed via a temporary register (TEMP). For details, see section
16.3, Interface to Bus Master.
The ADDR registers are initialized to H'0000 by a reset, and in standby mode or module stop
mode.
Table 16.3 Analog Input Channels and Corresponding ADDR Registers
Analog Input Channel
Group 0 Group 1 A/D Data Register
AN0 AN4 ADDRA
AN1 AN5 ADDRB
AN2 AN6 ADDRC
AN3 AN7 ADDRD