Datasheet

Section 14 Serial Communication Interface (SCI)
Rev.6.00 Sep. 27, 2007 Page 649 of 1268
REJ09B0220-0600
Wait
<Transfer start>
Start of initialization
Set data transfer format in
SMR and SCMR
No
Yes
Set value in BRR
Clear TE and RE bits in SCR to 0
[2]
[3]
Set TE or RE bit in SCR to 1, and
set RIE, TIE, TEIE, and MPIE bits
as necessary
Note: In simultaneous transmit and receive operations, the TE and RE bits should
both be cleared to 0 or set to 1 simultaneously.
[4]
1-bit interval elapsed?
Set CKE1 and CKE0 bits in SCR
(TE, RE bits 0)
[1]
[1] Set the clock selection in SCR. Be sure
to clear bits RIE, TIE, TEIE, and MPIE,
TE and RE, to 0.
[2] Set the data transfer format in SMR
and SCMR.
[3] Write a value corresponding to the bit
rate to BRR. (Not necessary if an
external clock is used.)
[4] Wait at least one bit interval, then set
the TE bit or RE bit in SCR to 1.
Also set the RIE, TIE, TEIE, and MPIE
bits as necessary.
Setting the TE or RE bit enables the
TxD or RxD pin to be used.
Figure 14.15 Sample SCI Initialization Flowchart