Datasheet

Section 8 Data Transfer Controller
Rev.6.00 Sep. 27, 2007 Page 319 of 1268
REJ09B0220-0600
8.2.7 DTC Enable Registers (DTCER)
Bit : 7 6 5 4 3 2 1 0
DTCE7 DTCE6 DTCE5 DTCE4 DTCE3 DTCE2 DTCE1 DTCE0
Initial value : 0 0 0 0 0 0 0 0
R/W : R/W R/W R/W R/W R/W R/W R/W R/W
The DTC enable registers comprise six 8-bit readable/writable registers, DTCERA to DTCERF,
with bits corresponding to the interrupt sources that can activate the DTC. These bits enable or
disable DTC service for the corresponding interrupt sources.
The DTC enable registers are initialized to H'00 by a reset and in hardware standby mode.
Bit n—DTC Activation Enable (DTCEn)
Bit n
DTCEn Description
0 DTC activation by this interrupt is disabled (Initial value)
[Clearing conditions]
• When the DISEL bit is 1 and the data transfer has ended
• When the specified number of transfers have ended
1 DTC activation by this interrupt is enabled
[Holding condition]
When the DISEL bit is 0 and the specified number of transfers have not ended
(n = 7 to 0)
A DTCE bit can be set for each interrupt source that can activate the DTC. The correspondence
between interrupt sources and DTCE bits is shown in table 8.5, together with the vector numbers
generated by the interrupt controller.
For DTCE bit setting, read/write operations must be performed using bit-manipulation instructions
such as BSET and BCLR. For the initial setting only, however, when multiple activation sources
are set at one time, it is possible to disable interrupts and write after executing a dummy read on
the relevant register.