Datasheet

Section 7 DMA Controller (Not Supported in the H8S/2321)
Rev.6.00 Sep. 27, 2007 Page 253 of 1268
REJ09B0220-0600
7.4.2 DMA Terminal Control Register (DMATCR)
Bit : 7 6 5 4 3 2 1 0
— — TEE1 TEE0 — — — —
Initial value : 0 0 0 0 0 0 0 0
R/W : — — R/W R/W — — — —
DMATCR is an 8-bit readable/writable register that controls enabling or disabling of DMAC
transfer end pin output. A port can be set for output automatically, and a transfer end signal
output, by setting the appropriate bit.
DMATCR is initialized to H'00 by a reset, and in hardware standby mode.
Bits 7 and 6—Reserved: Read-only bits, always read as 0.
Bit 5—Transfer End Enable 1 (TEE1): Enables or disables transfer end pin 1 (TEND1) output.
Bit 5
TEE1 Description
0 TEND1 pin output disabled (Initial value)
1 TEND1 pin output enabled
Bit 4—Transfer End Enable 0 (TEE0): Enables or disables transfer end pin 0 (TEND0) output.
Bit 4
TEE0 Description
0 TEND0 pin output disabled (Initial value)
1 TEND0 pin output enabled
The TEND pins are assigned only to channel B in short address mode.
The transfer end signal indicates the transfer cycle in which the transfer counter reached 0,
regardless of the transfer source. An exception is block transfer mode, in which the transfer end
signal indicates the transfer cycle in which the block counter reached 0.
Bits 3 to 0—Reserved: Read-only bits, always read as 0.