Datasheet

Section 7 DMA Controller (Not Supported in the H8S/2321)
Rev.6.00 Sep. 27, 2007 Page 235 of 1268
REJ09B0220-0600
Bit 6—Data Transfer Enable 1A (DTE1A): Enables or disables data transfer on channel 1A.
Bit 6
DTE1A Description
0 Data transfer disabled (Initial value)
1 Data transfer enabled
Bit 5—Data Transfer Enable 0B (DTE0B): Enables or disables data transfer on channel 0B.
Bit 5
DTE0B Description
0 Data transfer disabled (Initial value)
1 Data transfer enabled
Bit 4—Data Transfer Enable 0A (DTE0A): Enables or disables data transfer on channel 0A.
Bit 4
DTE0A Description
0 Data transfer disabled (Initial value)
1 Data transfer enabled
Bits 3 to 0—Data Transfer End Interrupt Enable (DTIE): These bits enable or disable an
interrupt to the CPU or DTC when transfer ends. If the DTIE bit is set to 1 when DTE = 0, the
DMAC regards this as indicating the end of a transfer, and issues a transfer end interrupt request to
the CPU or DTC.
A transfer end interrupt can be canceled either by clearing the DTIE bit to 0 in the interrupt
handling routine, or by performing processing to continue transfer by setting the transfer counter
and address register again, and then setting the DTE bit to 1.
Bit 3—Data Transfer Interrupt Enable 1B (DTIE1B): Enables or disables the channel 1B
transfer end interrupt.
Bit 3
DTIE1B Description
0 Transfer end interrupt disabled (Initial value)
1 Transfer end interrupt enabled