Datasheet

Section 19 ROM
Rev.6.00 Sep. 27, 2007 Page 800 of 1268
REJ09B0220-0600
19.13.9 Register Configuration
The registers used to control the on-chip flash memory when enabled are shown in table 19.27.
In order to access the FLMCR1, FLMCR2, EBR1, and EBR2 registers, the FLSHE bit must be set
to 1 in SYSCR2 (except RAMER).
Table 19.27 Flash Memory Registers
Register Name Abbreviation R/W Initial Value Address
*
1
Flash memory control register 1 FLMCR1
*
6
R/W
*
3
H'00/H'80
*
4
H'FFC8
*
2
Flash memory control register 2 FLMCR2
*
6
R/W
*
3
H'00 H'FFC9
*
2
Erase block register 1 EBR1
*
6
R/W
*
3
H'00
*
5
H'FFCA
*
2
Erase block register 2 EBR2
*
6
R/W
*
3
H'00
*
5
H'FFCB
*
2
System control register 2 SYSCR2
*
7
R/W H'00 H'FF42
RAM emulation register RAMER R/W H'00 H'FEDB
Notes: 1. Lower 16 bits of the address.
2. Flash memory. Registers selection is performed by the FLSHE bit in system control
register 2 (SYSCR2).
3. In modes in which the on-chip flash memory is disabled, a read will return H'00, and
writes are invalid. Writes are also disabled when the FWE bit is cleared to 0 in
FLMCR1.
4. When a high level is input to the FWE pin, the initial value is H'80.
5. When a low level is input to the FWE pin, or if a high level is input and the SWE bit in
FLMCR1 is not set, these registers are initialized to H'00.
6. FLMCR1, FLMCR2, EBR1, and EBR2 are 8-bit registers. Only byte accesses are valid
for these registers, the access requiring 2 states.
7. The SYSCR2 register can only be used in the F-ZTAT version. In the mask ROM
version this register will return an undefined value if read, and cannot be modified.