Specifications

Renesas Microcomputers General Presentation

Development Environment - Emulator

Changes and Additions to Functions (3)

A start/stop function has been added, allowing the execution of routines specified

by the user immediately after the user program is stopped or immediately before it starts.

The user can thus have the selected functions run when the program stops

because of a break or is restarted after a break, etc.

R8C M16C M32C

Better Functionality!

1. Specify a user routine to be executed immediately

before execution of the user program starts

(immediately after the “Execute” button is clicked).

2. Specify a user routine to be executed immediately

after the user program is stopped

(immediately after the “Stop button” is clicked

and immediately after a break condition

is matched to stop the program).

The specifications for the indicated routines include restrictions.

If these restrictions are not observed, the emulator may not operate properly.

Be sure to read the user’s manual before using the software.

Control signals (e.g. reset) used by the E8a emulator

are cleared after the end of programming,

and the execution of a user program can be selected

in the flash-memory programming mode.

However, this is only selectable when power

is not being supplied by the E8a emulator.

740 R8C M16C M32CBetter Functionality!

*Not supported for the R8C/10 to 13 Groups.

NEW