Specifications
©2007. Renesas Technology Corp., All rights reserved.
Renesas Microcomputers General Presentation
Development Environment - Emulator
Pin Assignments of S0005ECK01H
*1: Input to or output from the user system.
*2: The symbol "#" means that the signal is active-low.
*3: The emulator monitors the GND signal of the user system to detect whether or not the user system
is connected.
*4: Signal names are not intended to correspond to those for the actual MCU. Refer to recommended circuits
and notes described in the Supplementary Information on Using the SHxxxx and connect only the required
signals. Other than UVCC_AUD, the signals are the same as those for the 36-pin interface. Supply the
operating voltage of the AUD to UVCC_AUD.
Notes:
• The GND bus leads, which are allocated on the center of the H-UDI port connector, must be connected to GND.
• When an MCU incorporating the AUD with the SSTL18 specification (e.g., the SH7785) is used, the emulator is
used with the same circuit as for the E200F. For details, refer to the E200F emulator additional document
(Supplementary Information on Using the SHxxxx).
H-UI Port connector
(top view)
N.C.
N.C.
N.C.
AUDCK
N.C.
TDO
RESET#*
2
N.C.
UVCC
UVCC_AUD
TCK
TMS
N.C.
N.C.
TDI
MPMD(GND)
UCON#(GND)*
3
ASEBRK#/
BRKACK*
2
N.C.
Signal*
4
1
2
3
4
5
6
8
13
14
15
16
7
9
10
11
12
17
18
19
Pin NO.
User reset
Note
N.C.
TRST# *
2
N.C.
AUDATA2
AUDATA0
AUDATA1
N.C.
AUDRST#*
2
AUDMD
N.C.
N.C.
AUDATA3
AUDSYNC#*
2
N.C.
N.C.
N.C.
N.C.
N.C.
N.C.
Signal*
4
20
21
22
23
24
25
27
32
33
34
35
26
28
29
30
31
36
37
38
Pin NO.
Note
-
-
Input/
Output*
1
Output
Input/
Output
Output
Output
Output
Output
Input
Input
Input
-
-
-
-
-
-
-
-
Input/
Output *
1
Output
Input
-
-
-
-
-
-
-
-
-
-
-
-
-
Output
Output
Output
Output
25