User manual

RL78/G1A CHAPTER 16 INTERRUPT FUNCTIONS
Table 16-3. Interrupt Request Signal Corresponding to EGPn and EGNn bits
Detection Enable Bit
Edge Detection
Port
Interrupt Request
Signal
64-pin 48-pin 32-pin 25-pin
EGP0 EGN0 P137 INTP0
√ √ √ √
EGP1 EGN1 P50 INTP1
√ √ √ √
EGP2 EGN2 P51 INTP2
√ √ √ √
EGP3 EGN3 P30 INTP3
√ √ √ √
EGP4 EGN4 P31 INTP4
√ √ √ √
EGP5 EGN5 P16 INTP5
√ √ − −
EGP6 EGN6 P140 INTP6
√ √ − −
EGP7 EGN7 P141 INTP7
√ − − −
EGP8 EGN8 P74 INTP8
√ √ − −
EGP9 EGN9 P75 INTP9
√ √ − −
EGP10 EGN10 P76 INTP10
√ − − −
EGP11 EGN11 P77 INTP11
√ − − −
Caution When the input port pins used for the external interrupt functions are switched to the output mode,
the INTPn interrupt might be generated upon detection of a valid edge.
When switching the input port pins to the output mode, set the port mode register (PMxx) to 0 after
disabling the edge detection (by setting EGPn and EGNn to 0).
Remarks 1. For edge detection port, see 2.1 Port Function.
2. n = 0 to 11
R01UH0305EJ0200 Rev.2.00 704
Jul 04, 2013