User's Manual

Target Board for RX23W 5. User Circuit
R01UHxxxEG0100
Rev.0.60 Page 14 of 28
Nov. 26, 2019
Emulator
This board has an emulator. When shipped from the factory, the switch is off and the emulator is in reset. If you
are using an emulator, set the switches as shown in Table 5-1.The connector shape is USB micro -B for
Integrated Development Environment (IDE) and for Renesas Flash Programmer (RFP). Connect to the
computer via the USB cable. If the power supply on the host side is ON, the Target Board for RX23W will be
automatically power-supplied with the cable connection.
Note:
USB cable is not included in the package
Figure 5-2
： Switch to reset the emulator ESW1
Table 5-1: Switch to reset the emulator ESW1
ESW1
Function
1ch
Not functional
－
－
2ch
Switch to reset the emulator
OFF
The emulator is reset
Emulator is not available
ON
Emulator is available
Switch to reset
the emulator
ESW1