Users Manual

R01UH0823EJ0110 Rev.1.10 Page 1232 of 1852
Nov 30, 2020
RX23W Group 36. CAN Module (RSCAN)
36.2.34 Receive FIFO Control Register m (RFCCm) (m = 0, 1)
RFE Bit (Receive FIFO Buffer Enable)
Setting the RFE bit to 1 makes receive FIFO buffers available. Setting this bit to 0 sets the RFSTSm.RFEMP flag to 1
(the receive FIFO buffer contains no unread message (buffer empty)). Modify this bit only in global operating mode or
global test mode.
RFIE Bit (Receive FIFO Interrupt Enable)
Setting the RFIE bit to 1 enables receive FIFO interrupts. Modify this bit when the RFE bit is set to 0 (no receive FIFO
buffer is used).
RFDC[2:0] Bits (Receive FIFO Buffer Depth Configuration)
These bits are used to select the number of messages that can be stored in a single receive FIFO buffer. If these bits are
set to 000b, do not use any receive FIFO buffer. Modify these bits only in global reset mode.
RFIM Bit (Receive FIFO Interrupt Source Select)
This bit is used to select a FIFO interrupt source. Modify this bit only in global reset mode.
Address(es): RSCAN.RFCC0 000A 8338h, RSCAN.RFCC1 000A 833Ah
b15b14b13b12b11b10b9b8b7b6b5b4b3b2b1b0
RFIGCV[2:0] RFIM— RFDC[2:0] ——————RFIERFE
Value after reset:
0000000000000000
Bit Symbol Bit Name Description R/W
b0 RFE Receive FIFO Buffer Enable 0: No receive FIFO buffer is used.
1: Receive FIFO buffers are used.
R/W
b1 RFIE Receive FIFO Interrupt Enable 0: Receive FIFO interrupt is disabled.
1: Receive FIFO interrupt is enabled.
R/W
b7 to b2 — Reserved These bits are read as 0. The write value should be 0. R/W
b10 to b8 RFDC[2:0] Receive FIFO Buffer Depth
Configuration
b10 b8
0 0 0: 0 messages
0 0 1: 4 messages
0 1 0: 8 messages
0 1 1: 16 messages
1 0 0: Setting prohibited
1 0 1: Setting prohibited
1 1 0: Setting prohibited
1 1 1: Setting prohibited
R/W
b11 — Reserved This bit is read as 0. The write value should be 0. R/W
b12 RFIM Receive FIFO Interrupt Source
Select
0: An interrupt occurs when the condition set by the
RFIGCV[2:0] bits is met.
1: An interrupt occurs each time a message has been
received.
R/W
b15 to b13 RFIGCV[2:0] Receive FIFO Interrupt Request
Timing Select
b15 b13
0 0 0: When FIFO is 1/8 full.
0 0 1: When FIFO is 2/8 full.
0 1 0: When FIFO is 3/8 full.
0 1 1: When FIFO is 4/8 full.
1 0 0: When FIFO is 5/8 full.
1 0 1: When FIFO is 6/8 full.
1 1 0: When FIFO is 7/8 full.
1 1 1: When FIFO is full.
R/W