Installation Guide

THE STEPS
• Using the template provided, measure and
cut the hole in the countertop.
• Determine the locations for the clip
brackets around the perimeter of the
sink. Pre-drill holes for the clips using
appropriate methods for the countertop
material.
• With denatured alcohol, clean the surfaces
of the sink and countertop which will meet.
• Evenly apply a bead of silicone along
perimeter edge of the opening on the
underside of the countertop.
• Carefully align the sink under the
countertop opening.
• Evenly apply pressure to the sink
securing a seal of the silicone against the
countertop.
• Re-check that the sink is evenly aligned
with the countertop.
• Attach and tighten the clip brackets against
the edge of the sink. Do not tighten one
screw completely before others. Partially
tighten one clip then the one across from it,
and so on until all clips are fully tightened.
This will safeguard against an uneven or
insecure installation.
• Remove any excess silicone along the sink
lip under the countertop.
• Use a cloth with denatured alcohol along
the inner perimeter of the sink and top of
counter to remove any excess sealant.
872.241.0016
Toledo, Ohio
[e-mail]
Renesinks.com
UNDERMOUNT
SINKS
Installation Guide
An undermount sink can be installed
in three different fashions.
• A ush mount allows the well
of the sink to line up perfectly
with the edge of the countertop
opening.
• A positive reveal allows a portion
of the sink rim to be exposed.
• A negative reveal allows the
countertop to slightly overlap the
interior of the basin.