Installation Guide

THE STEPS
Undermount:
• Using the template provided with your
purchase, measure and cut the hole in the
countertop.
• Determine the locations for the clip brackets
around the perimeter of the sink. Pre-
drill holes for the clips using appropriate
methods for the countertop material.
• With denatured alcohol, clean the area
where the surface of the sink will meet the
countertop.
• On the underside of the counter, apply a
bead of silicone along the perimeter edge of
the opening.
• Carefully align the sink under the countertop
opening and raise it into position, applying
pressure to secure a seal of the silicone
against the countertop.
• Re-check that the sink is evenly aligned with
the countertop.
• Attach and tighten the clip brackets against
the edge of the sink. Do not tighten one
screw completely before the others. To
872.241.0016
Toledo, Ohio
[e-mail]
renesinks.com
DUAL MOUNT
SINKS
Installation Guide
UNDERMOUNT TECHNIQUES
Note: Topmounting does not require clips.
begin, partially tighten one clip. Then, tighten
the clip directly across from it, and so on,
until all clips are fully tightened. This will
safeguard against an uneven or insecure
installation.
• With denatured alcohol and a cloth,
wipe along the perimeter of the sink and
countertop to remove any excess sealant.
Topmount:
• Using the template provided with your
purchase, measure and cut the hole in the
countertop.
• With denatured alcohol, clean the area
where the surface of the sink meets the
countertop.
• Evenly apply a bead of silicone along the top
perimeter edge of the counter opening.
• Carefully align the sink over the countertop
opening and lower into position, applying
pressure to secure a seal of the silicone
against the countertop.
• Re-check that the sink is evenly aligned with
the countertop.
• Attach and tighten the clip brackets against
the edge of the sink. Do not tighten one
screw completely before the others. To
begin, partially tighten one clip. Then, tighten
the clip directly across from it, and so on,
until all clips are fully tightened. This will
safeguard against an uneven or insecure
installation.
• With denatured alcohol and a cloth,
wipe along the perimeter of the sink and
countertop to remove any excess sealant.