Installation Guide

THE STEPS
• Using the template provided with your
purchase, measure and cut the hole in the
countertop.
• Determine the locations for the clip
brackets around the perimeter of the
sink. Pre-drill holes for the clips using
appropriate methods for the countertop
material.
• With denatured alcohol, clean the area
where the surface of the sink will meet the
countertop.
• Evenly apply a bead of silicone along
perimeter edge of the opening on the top
of the counter.
• Carefully align the sink over the countertop
opening and lower into position, applying
pressure to secure a seal of the silicone
against the countertop.
• Re-check that the sink is evenly aligned
with the countertop.
• Attach and tighten the clip brackets
against the edge of the sink. Do not tighten
one screw completely before the others.
To begin, partially tighten one clip. Then,
tighten the clip directly across from it, and
so on, until all clips are fully tightened.
This will safeguard against an uneven or
insecure installation.
• With denatured alcohol and a cloth,
wipe along the perimeter of the sink and
countertop to remove any excess sealant.
872.241.0016
Toledo, Ohio
[e-mail]
renesinks.com
TOPMOUNT
SINKS
Installation
Shown here is an illustration of
the clip style and how it attaches
when installing a René topmount
stainless steel sink.
STAINLESS STEEL
TOPMOUNT CLIP
(US Series)