Specifications

seat belts ............................................................... (current page)
methods of restraint in addition to rear seat belts..(current page)
1.33
ENG_UD7170_2
Dispositifs complémentaire aux ceintures arrière (X83 - Renault)ENG_NU_881-5_X83_Renault_1
Dispositifs complémentaires à la ceinture arrière
METHODS OF RESTRAINT IN ADDITION TO REAR SEAT BELTS
Depending on the vehicle, they are
composed of:
– pretensioners integrated into the
inertia reel,
– force limiters.
These systems are designed to act in-
dependently or together when the vehi-
cle is subjected to a frontal impact.
There are two possibilities, depending
on the force of the impact:
– protection is provided by the seat
belt only;
– the pretensioner is triggered to rec-
tify seat belt slack.
Rear side seat belt
pretensioners
The system is operational a few sec-
onds after the ignition has been
switched on.
If the vehicle is subjected to a severe
frontal, side or rear impact, a device
retracts the seat belt and pulls it against
the body, thereby increasing its effec-
tiveness.
Force limiter
Above a certain level of impact force,
this mechanism is used to limit the force
of the belt against the body so that it is
at an acceptable level.
– Have the entire restraint
system checked following
an accident.
– No operation whatso-
ever is permitted on any part of
the system (pretensioners, air
bags, computers, wiring) and the
system components must not
be reused on any other vehicle,
even if identical.
– To avoid incorrect triggering of
the system which may cause
injury, only qualified personnel
from an approved dealer may
work on the pretensioner and air
bag system.
– The electric trigger system may
only be tested by a specially
trained technician using special
equipment.
– When the vehicle is scrapped,
contact an approved dealer for
disposal of the pretensioner and
air bag gas generators.