Specifications
tool kit ...................................................(up to the end of the DU)
hubcap tool ...........................................(up to the end of the DU)
jack .......................................................(up to the end of the DU)
puncture................................................(up to the end of the DU)
wheelbrace ...........................................(up to the end of the DU)
wheel trim .............................................(up to the end of the DU)
emergency spare wheel .......................(up to the end of the DU)
5.6
ENG_UD19992_4
Bloc-outils (L43 - Renault)ENG_NU_949-3_L43_Renault_5
Tool kit (jack - wheelbrace, etc.)
Wheel trim
The tool kit is located under the lug-
gage compartment carpet (tools varies
depending on the vehicle).
1
When replacing the jack, fold it cor-
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
2
Refer to the information on “Towing” in
Section 5.
3
4
This tool is used to remove the wheel
trims.
5
6
Remove it using hubcap tool 4 by en-
gaging the hook in the opening pro-
vided near valve 7.
To refit the hubcap, align it with valve 7.
Push the retaining hooks in fully, start-
ing with side C near the valve, followed
by D and E, finishing at F opposite the
valve.
if you are using anti-theft bolts,
refer to the information on “Changing a
wheel”.
Do not leave the tools un-
secured inside the vehicle
as they may come loose
under braking. After use,
check that all the tools are correctly
clipped into the tool kit, then position
it correctly in its housing: there is a
risk of injury.
If wheel bolts are supplied in the
tool kit, only use these bolts for the
emergency spare wheel: refer to the
label affixed to the emergency spare
wheel.
The jack is designed for
wheel changing purposes
only. Under no circum-
stances should it be used
for carrying out repairs underneath
the vehicle or to gain access to the
underside of the vehicle.