Specifications

82A-12
ENGINE IMMOBILISER
Ignition switch: Removal - Refitting
82A
a Tighten the shear bolt (14) until the bolt head shears
off.
a Connect the starter switch connector.
a Lock the starter switch connector.
III - FINAL OPERATION.
a Clip on the wiring harness clip (15) .
a Refit:
- the antenna/transponder ring (see 82A, Engine
immobiliser, Transponder ring: Removal - Re-
fitting, page 82A-13) ,
- the steering column switch assembly (see 84A,
Control - Signals, Steering column switch as-
sembly: Removal - Refitting, page 84A-4) ,
- the lower half-shell.
a Clip on:
- the dashboard gaiter on the upper half cowling (9) ,
- the upper half cowling to the lower half cowling.
a Refit:
- the bolts (8) under the lower half cowling,
- the steering wheel (see Steering wheel: Removal
- Refitting) (MR 392, 36B, Power-assisted steer-
ing),
- the driver's front airbag (see 88C, Air bag and Pre-
tensioners, Driver's frontal airbag: Removal -
Refitting, page 88C-22) .
a Connect the connectors on the lower cover (7) .
a Refit:
- the lower cover (7) ,
- the dashboard lower trim (6) .
a Tighten:
- the dashboard lower trim bolt (5)
- the lower cover bolt (3) ,
a Clip on:
- the plastic rivet,
- the dashboard side panel,
- the trim (1) ,
- the door seal,
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
108439
117403