Specifications

80B-40
HEADLIGHTS
Front lighting computer: Removal - Refitting
DISCHARGE LAMPS
80B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-1) .
a Remove the front bumper (see Front bumper: Re-
moval - Refitting) (MR 393, 55A, Exterior protec-
tion).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connectors (1) .
a Remove:
- the bolt (2) ,
- the computer.
a Remove the nut (3) from the computer mounting.
a Withdraw the mounting.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Fit the computer support.
a Refit the computer.
a Connect the connectors.
II - FINAL OPERATION.
a Refit the front bumper (see Front bumper: Remov-
al - Refitting) (MR 393, 55A, Exterior protection).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a If replacing the discharge bulb computer, carry out
the necessary operations using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 394, 80B, Headlights).
Equipment required
Diagnostic tool
Note:
The computer controls the additional cornering
lights and the xenon bulbs (depending on the
vehicle equipment level).
113503
113504