Specifications

80B-37
HEADLIGHTS
Headlight beam adjustment rear sensor: Removal - Refitting
80B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR392, 02, Lifting equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Unlock the clip of the return linkage (1) .
a Remove the rear height sensor support mounting
bolt (2) .
a Disconnect the rear height sensor.
a Remove the rear height sensor with its support.
REFITTING
I - REFITTING PREPARATIONS OPERATION
a
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the rear height sensor with its support.
a Connect the rear height sensor.
a Refit the rear height sensor support mounting bolt.
a Torque tighten the rear height sensor support
mounting bolts (8 Nm).
a Clip on the return linkage clip.
a If replacing the rear height sensor, carry out the nec-
essary operations using the Diagnostic tool (see
Fault finding - Replacement of components) (MR
394, 80B, Headlights).
Equipment required
Diagnostic tool
Tightening torquesm
rear height sensor sup-
port mounting bolts
8 Nm
115052
WARNING
The headlight beam adjustment sensor clip is
very fragile. If the clip breaks during the removal
operation, the whole headlight beam adjustment
sensor must be replaced.