Specifications

80B-36
HEADLIGHTS
Headlight beam adjustment front sensor: Removal - Refitting
DISCHARGE LAMPS
80B
a Remove the steering box bolt (3) .
a Unclip the bracket ball joint (4) .
a Remove the headlight beam adjustment front sensor
with its mounting (5) .
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the headlight beam adjustment front sensor.
a Refit the linkage on the flat surface of the anti-roll
bar.
a Refit the bolt of the height sensor support.
a Retighten the linkage bolt.
a Connect the headlight beam adjustment front sensor
connector.
a Fit the headlight beam adjustment front sensor with
its mounting.
a Refit the steering box bolt.
a Clip the ball joint onto the bracket.
a Torque tighten the steering box bolt (105 N.m).
II - FINAL OPERATION
a Refit:
- the front wheels (see Vehicle: Towing and lifting)
(MR 392, 02A, Lifting equipment),
- the front axle subframe (see Front axle subframe:
Removal - Refitting) (MR 392, 31A, Front axle
components).
a If replacing the headlight beam adjustment front
sensor, carry out the necessary operations using the
Diagnostic tool (see MR 394 Fault finding, 80B,
Headlights, Fault finding - Replacement of com-
ponents).
EQUIPMENT LEVEL SPORT
122110
EQUIPMENT LEVEL EA1 or EQUIPMENT LEVEL
EA2 or EQUIPMENT LEVEL EA3 or EQUIPMENT
LEVEL EA4 or EQUIPMENT LEVEL EA5
EQUIPMENT LEVEL SPORT