Specifications

80B-33
HEADLIGHTS
Remote headlight beam adjustment actuator: Removal - Refitting
DOCUMENTATION PHASE 2
80B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlight (see 80B, Headlights, Headlight:
Removal - Refitting, page 80B-7) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Press on (1) .
a Unclip the beam adjustment actuator (2) by turning it
a quarter of a turn clockwise.
a Remove the beam adjustment actuator by unclip-
ping the ball joint from the clip groove.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Remove the sealing cover (3) .
a Pull the reflector shell to bring the clip groove as
close as possible to the ball joint of the beam adjust-
ment actuator.
a Fit the beam adjustment actuator ball joint in the clip
groove (4) .
a Clip the beam adjustment actuator by turning it a
quarter of a turn anti-clockwise.
II - FINAL OPERATION
a Refit:
- the sealing cover,
- the headlight (see 80B, Headlights, Headlight:
Removal - Refitting, page 80B-7) .
a Adjust the headlight beam (see 80B, Headlights,
Headlight: Adjustment, page 80B-9) .
a Refit:
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
139596
141043
Note:
The ball joint should not just be in contact with
the groove, it should be fitted into it.