Specifications

80B-32
HEADLIGHTS
Remote headlight beam adjustment actuator: Removal - Refitting
DOCUMENTATION PHASE 1
80B
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Remove the sealing cover (4) .
a Pull the reflector shell (headlight lens unit) towards
you to bring the clip groove as close as possible to
the ball joint.
a Insert the ball joint into clip groove (5)
a Clip in the actuator.
II - FINAL OPERATION
a Refit:
- the sealing cover,
- the headlight (see 80B, Headlights, Headlight:
Removal - Refitting, page 80B-7) .
a Lower the vehicle.
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a Adjust the headlight beam (see 80B, Headlights,
Headlight: Adjustment, page 80B-9) .
a Refit:
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres).
112960
115045
Note:
The ball joint should not just be in contact with
the groove, it should be fitted into it.
DISCHARGE LAMPS