Specifications

80B-31
HEADLIGHTS
Remote headlight beam adjustment actuator: Removal - Refitting
DOCUMENTATION PHASE 1
80B
a
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-1) .
a Remove:
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlight (see 80B, Headlights, Headlight:
Removal - Refitting, page 80B-7) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Press on (1) .
a Unclip the actuator (2) by rotating it a quarter of a
turn clockwise while pressing the clip (3) .
a Remove the actuator by unclipping the actuator ball
joint from the clip groove.
DISCHARGE LAMPS
IMPORTANT
To prevent burns, wait until the « computers -
power unit » assemblies are cold before removal.
IMPORTANT
To prevent eye injuries:
-do not look at a xenon bulb when lit (voltage
when lit 20000 V),
- do not light a bulb which has not been fitted into
its headlight.
DISCHARGE LAMPS
115041