Specifications

88C-35
AIR BAG AND PRETENSIONERS
Anti-submarining airbag: Removal - Refitting
C85
88C
a Torque tighten the anti-submarining airbag
mounting bolts (21 Nm) starting with bolts (3) and
(4) .
a Connect:
- the earth terminal,
- the airbag module connector, checking that it is
locked correctly.
III - FINAL OPERATION.
a Refit:
- the seat base trim (see Front seat base trim: Re-
moval - Refitting) (MR 393, 77A, Front seat trim),
- the seat (see Complete front seat: Removal - Re-
fitting) (MR 393, 75A, Front seat frames and run-
ners).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a Unlock the airbag computer (see Fault finding - Re-
placement of components)(MR 394, 88C, Airbags
and seat belt pretensioners).
(see 88C, Air bag and Pretensioners, Airbags
and pretensioners: Recycling - Destruction,
page 88C-7) .
IMPORTANT
Check the airbag computer using the Diagnostic
tool. Any failure to follow these instructions may
lead to system malfunctions, or even result in the
incorrect triggering of the airbags.
IMPORTANT
Do not reuse the pyrotechnic components. The
pretensioners or airbags on a vehicle which is to
be scrapped must be destroyed.