Specifications

88C-21
AIR BAG AND PRETENSIONERS
Rear pyrotechnic inertia reel: Removal - Refitting
B85 or C85 or K85
88C
a Remove the seat belt upper mounting bolt (1) .
a Disconnect the connector (2) from the pyrotechnic
inertia reel.
a Remove:
- the mounting bolt (3) from the inertia reel,
- the pyrotechnic inertia reel.
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the mounting bolt for the pyrotechnic
inertia reel.
a
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the reel.
a Torque tighten the inertia reel mounting bolt (21
Nm).
a Connect the inertia reel connector.
a Torque tighten the seat belt upper mounting bolt
(21 Nm).
a Torque tighten the seat belt lower mounting bolt
(21 Nm).
III - FINAL OPERATION.
a Refit the rear quarter panel trim (see Quarter panel
trim: Removal - Refitting) (MR 393, 71A, Body in-
ternal trim).
a Refit the rear door sill upper lining (see Rear inner
sill upper trim: Removal - Refitting) (MR 393,
71A, Body internal trim).
a Refit the rear wing panel trim (see Rear panel lin-
ing: Removal - Refitting) (MR 393, 71A, Body in-
ternal trim).
a Refit the rear bench seat (see Single unit rear
bench seatback: Removal - Refitting) or (see 1/3
and 2/3 rear bench seatback: Removal - Refit-
ting) (MR 393, 76A, Rear seat frames and runners).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a If all is correct, unlock the airbag computer (see
Fault finding - Replacement of components)(MR
394, 88C, Airbags and seat belt pretensioners).
(see 88C, Air bag and Pretensioners, Airbags
and pretensioners: Recycling - Destruction,
page 88C-7) .
112413
IMPORTANT
After a seat belt pyrotechnic component is trig-
gered, it is essential to replace certain parts.
(see Airbag and pretensioners: Precautions
for repair) (88C, Airbags and pretensioners).
B85 or K85
C85
IMPORTANT
Check the airbag computer using the Diagnostic
tool. Any failure to follow these instructions may
lead to system malfunctions, or even result in the
accidental triggering of the airbags.
IMPORTANT
Do not reuse the pyrotechnic components. The
pretensioners or airbags on a vehicle which is to
be scrapped must be destroyed.