Specifications

88C-10
AIR BAG AND PRETENSIONERS
Airbag computer: Removal - Refitting
88C
a Unclip the connector latch (2) .
a Disconnect the connector.
a Remove:
- the mounting nuts (3) from the computer,
- the computer.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Position the computer.
a Torque tighten the computer mounting nuts (8
Nm).
a Connect the connector.
a Replace the computer's protective housing with a
new one.
a Attach the carpet at (4) with the clips (part number:
77 01 047 751).
II - FINAL OPERATION.
a Refit the centre console (see MR 393 Bodywork,
57A, Interior equipment, Centre console: Re-
moval - Refitting).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a If replacing the airbag computer, carry out the nec-
essary operations using the Diagnostic tool (see
MR 394 Fault finding, 88C, Airbags and seat belt
pretensioners, Fault finding - Replacement of
components).
a If all is correct, unlock the airbag computer (see MR
394 Fault finding, 88C, Airbags and pretension-
ers, Fault finding - Replacement of components).
112452 109900
IMPORTANT
Check the airbag computer using the Diagnostic
tool. Any failure to follow these instructions may
lead to system malfunctions, or even result in the
incorrect triggering of the airbags.