Specifications

88A-152
WIRING HARNESS
Rear wiring: Removal - Refitting
C85 or S85
88A
a Connect the parking distance control buzzer con-
nector.
a Refit the parking distance control computer (see
87F, Parking distance control, Parking distance
control computer: Removal - Refitting, page 87F-
6) .
a Fit the wiring under the body.
a Connect the rear right-hand and left-hand wheel
speed sensor connector.
a Clip on the right-hand and left-hand wheel speed
sensor clip.
a Refit the rear right-hand and left-hand wheel arch
liners (see Rear wheel arch liner: Removal - Refit-
ting) (MR 393, 55A, Exterior protection).
a Connect the rear starter aerial connector.
a Connect the fuel sender connector.
a Close the fuel gauge flap.
a Connect the tyre pressure monitoring computer con-
nector.
a Connect:
- the connector for the front pyrotechnic inertia reels,
- the connector for the impact sensors,
- the airbag computer connector.
a Clip on the airbag computer connector lock.
a Connect:
- the R 374 connector,
- the R 2 connector.
II - FINAL OPERATION.
a Refit:
- the rear lights on the wing (see 81A, Rear lighting,
Rear wing light: Removal - Refitting, page 81A-
5) .
- the tailgate trim (see Tailgate trim: Removal - Re-
fitting) (MR 393, 73A, Non-side opening elements
trim),
- the rear soundproofing of centre floor (see Centre
floor rear soundproofing: Removal - Refitting)
(MR 393, 68A, Soundproofing),
- the side soundproofing of centre floor (see Centre
floor side soundproofing: Removal - Refitting)
(MR 393, 68A, Soundproofing),
- the front centre floor carpet (see Centre floor front
carpet: Removal - Refitting) (MR 393, 71A, Body
internal trim),
- the rear centre floor carpet (see Centre floor rear
carpet: Removal - Refitting) (MR 393, 71A, Body
internal trim),
-the centre console (see Centre console: Removal
- Refitting) (MR 393, 57A, Interior equipment),
- the rear panel trims (see Rear panel lining: Re-
moval - Refitting) (MR 393, 71A, Body internal
trim),
- the front door sill inner trims (see Front door sill
lining: Removal - Refitting) (MR 393, 71A, Body
internal trim),
- the wheel arch trims (see Rear wheel arch trim:
Removal - Refitting) (MR 393, 71A, Body internal
trim),
- the rear quarter panel trims (see Quarter panel
trim: Removal - Refitting) (MR 393, 71A, Body in-
ternal trim),
-the rear bench seatback (see Single unit rear
bench seatback: Removal - Refitting) or (see 1/3
and 2/3 rear bench seatback: Removal - Refit-
ting) (depending on the equipment level) (MR 393,
76A, Rear seat frames and runners),
- the rear bench seat base (see Single unit rear
bench seat base: Removal - Refitting) or (see 1/
3 and 2/3 rear bench seat base: Removal - Refit-
ting) (depending on the equipment level) (MR 393,
76A, Rear seat frames and runners),
- the front seats (see Complete front seat: Remov-
al - Refitting) (MR 393, 75A, Front seat frames
and runners),
PROXIMITY RADAR
ELECTRONIC STABILITY PROGRAM
VEHICLE WITH CARD
TYRE PRESSURE SENSOR