Specifications

88A-151
WIRING HARNESS
Rear wiring: Removal - Refitting
C85 or S85
88A
- the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, page 81A-
10) .
a Remove the rear bumper (see Rear bumper: Re-
moval - Refitting) (MR 393, 55A, Exterior protec-
tion).
a Unclip the rear bumper absorber connector.
a Disconnect the connector (18) from the opening
aerial.
a Unclip the rear wiring.
a Remove the rear wiring.
REFITTING
a If replacing with more wiring, lock the unused con-
nectors (see Connector: Sealing and immobilisa-
tion) (Technical Note 6015A, 88A, Wiring).
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the rear wiring.
a Clip on the rear wiring.
a Connect the opening aerial connector.
a Clip the opening aerial connector onto the rear
bumper absorber.
a Refit the rear bumper (see Rear bumper: Removal
- Refitting) (MR 393, 55A, Exterior protection).
a Refit:
- the tailgate lock (see Tailgate lock: Removal - Re-
fitting) ,
- the tailgate opening switch (see 87C, Opening el-
ement management, Tailgate opening switch:
Removal - Refitting, page 87C-5) ,
-the high level brake light (see 81A, Rear lighting,
3rd brake light: Removal - Refitting, page 81A-
10) .
a Connect the tailgate locking switch connector.
a Connect:
- the heated rear screen connectors,
- the rear screen wiper motor connector.
a Connect:
- the R 319 connector,
-the right-hand and left-hand side curtain airbag
connector,
- the fuel filler flap locking motor connector,
- the right-hand and left-hand earth terminals,
- the rear pyrotechnic inertia reel connector,
- the R 325 connector,
- the radio aerial connector.
a Torque tighten the earth terminal nuts (8 Nm).
VEHICLE WITH CARD
113333
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).
VEHICLE WITH CARD
VEHICLE WITH CARD