Specifications

88A-105
WIRING HARNESS
Dashboard wiring: Removal - Refitting
RIGHT-HAND DRIVE
88A
a Disconnect the starter aerial connector (26) .
a Unclip the wiring.
a Remove the wiring.
REFITTING
a If replacing with more wiring, lock the unused con-
nectors (see Connector: Sealing and immobilisa-
tion) (Technical Note 6015A, 88A, Wiring).
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the harness.
a Attach the wiring.
a Connect the centre console starter aerial connector.
a Connect the lateral acceleration and yaw sensor
connector.
a Connect:
- the earth (23) ,
- the airbag computer connector,
- the handbrake switch.
a Torque tighten the earth terminal nut (8 Nm).
a Clip:
- the passenger compartment fuse and relay box.
- the heating resistor relay unit.
a Connect:
- the brake light switch connector,
- the clutch pedal sensor connectors,
- the fan assembly control unit connector,
- the heating resistor connector,
- the R 99 connector.
a Connect the electric steering column lock connector.
a Connect:
- the antenna/transponder ring connector,
- the starter switch connector.
a Clip the wiring on the steering column.
a Connect:
- the electric power assisted steering connectors,
VEHICLE WITH CARD
113221
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).
VEHICLE WITH CARD
ELECTRONIC STABILITY PROGRAM
VEHICLE WITH CARD
VEHICLE WITH KEY