Specifications

88A-89
WIRING HARNESS
Dashboard wiring: Removal - Refitting
LEFT-HAND DRIVE
88A
a Disconnect the dashboard starter aerial connector
(1) .
a Remove:
-the A-pillar trims (see Windscreen pillar trim: Re-
moval - Refitting) (MR 393, 71A, Body internal
trim),
-the centre console (see Centre console: Removal
- Refitting) (MR 393, 57A, Interior equipment),
- the tweeters (see 86A, Radio, Tweeter: Removal
- Refitting, page 86A-13) ,
- the dashboard (see Dashboard: Removal - Refit-
ting) (MR 393, 57A, Interior equipment),
-the front left-hand door sill lining (see Front door
sill lining: Removal - Refitting) (MR 393, 71A,
Body internal trim),
-the air conditioning control panel (see Control
panel: Removal - Refitting) (MR 392, 61A, Heat-
ing),
a Move aside the front left-hand section of the centre
floor front carpet.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
a Open the driver's door.
a Unclip the R 3 connector latch (2) .
a Disconnect the R3 connector.
a Remove:
- the foam (3) ,
- The R 3 connector bolts (4) .
a Remove the dashboard wiring harness from the
body.
a Open the passenger door.
VEHICLE WITH CARD
112796
WARNING
To prevent any risk of noise, premature wear,
short circuits, etc. after the refitting operation,
mark the wiring routing and how to connect the
connectors.
123901