Specifications

88A-68
WIRING HARNESS
Engine wiring: Removal - Refitting
F4R
88A
a Remove:
- the gearbox earth cable bolt (19) ,
-the nut on the excitation terminal of the starter (20)
,
- the nut on the positive terminal of the starter (21) .
a Remove the air resonator (see Air resonator: Re-
moval - Refitting) (MR 392, 12A, Fuel mixture).
a Disconnect:
- the fuel injection computer connectors (22) ,
- the engine cooling fan assembly connector (23) ,
- the engine cooling fan assembly resistor connector
(24) ,
- the refrigerant pressure sensor connector (25) ,
- the Protection and Switching Unit connectors (26) ,
- the front left-hand wiring connector (32) .
a Remove:
- the engine cooling fan assembly earth wiring nut
(27) on the front left-hand side member,
- the 30 A fuse from the power feed fuse board,
- the fuse holder (28) ,
- the nut (29) from the power feed fuse board cable,
- the fuel injection computer earth wiring nut (30) .
a Unclip:
- the sub-frame and cylinder block wiring,
- the engine cooling fan assembly wiring,
- the cylinder head wiring.
a Remove the engine wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a If replacing with more wiring, lock the unused con-
nectors (see Connectors: Sealing and immobili-
sation) (Technical Note 6015A, 88A, Wiring).
124229
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).