Specifications

80B-17
HEADLIGHTS
Headlight bulb: Removal - Refitting
DOCUMENTATION PHASE 1
80B
REMOVAL
a
I - REMOVAL PREPARATION OPERATION
a Switch off the ignition.
The side light bulbs, dipped headlight bulbs, main
beam headlight bulbs and additional cornering
light bulbs require removal of the headlight
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-1) .
a Remove:
- the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the headlight (see 80B, Headlights, Headlight:
Removal - Refitting, page 80B-7) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Direction indicator bulb
a Unlock the bulb holder (1) by turning it a quarter of a
turn anti-clockwise.
a Remove the direction indicator bulb from the bulb
holder.
2 - Side light bulbs
a Remove the sealing cover (2) .
DISCHARGE LAMPS
IMPORTANT
To prevent eye injuries:
-do not look at a xenon bulb when lit (voltage
when lit 20000 V),
- do not light a bulb which has not been fitted into
its headlight.
IMPORTANT
To prevent burns, wait until the « computers -
power unit » assemblies are cold before removal.
DISCHARGE LAMPS
112959
112962