Specifications

88A-58
WIRING HARNESS
Engine wiring: Removal - Refitting
K9K
88A
- the engine wiring mounting bolt on the clutch hous-
ing.
a Tighten the engine wiring harness mounting bolt on
the clutch housing.
a Refit the sequential gearbox computer (see Se-
quential gearbox converter: Removal - Refitting)
(MR 392, 21B, Sequential gearbox).
a Connect the sequential gearbox pump assembly
connectors.
a Refit the sequential gearbox earth wiring nuts on the
front left-hand side member.
a Torque tighten the sequential gearbox earth wir-
ing nuts on the front left-hand side member (8
Nm).
a Refit:
- the heating element nuts,
- the earth wiring from the heating element unit sup-
port on the gearbox.
a Tighten:
- the heating element nuts (4 Nm),
- the earth wiring bolt from the heating element
unit support on the gearbox (21 Nm).
a Connect:
- the particle filter downstream temperature sensor
connector,
- the particle filter upstream temperature sensor con-
nector,
- the catalytic converter downstream temperature
sensor connector,
-the diesel injector connector to the catalytic pre-
converter,
- the particle filter pressure sensor connector.
a Refit the nut from the power feed fuse board cable.
a Torque tighten the nut from the power feed fuse
board cable (6 Nm).
a Refit the engine cooling fan assembly earth cable
nut on the front left-hand side member.
a Torque tighten the engine cooling fan assembly
earth cable nut on the front left-hand side mem-
ber (8 Nm).
a Refit:
- the fuse holders,
- the 30 A fuses from the power feed fuse board.
a Refit the earth wiring bolt on the gearbox.
a Tighten the earth wiring bolt on the gearbox (24
Nm).
a Refit:
- the nut on the positive terminal of the starter,
- the nut on the excitation terminal of the starter.
a Tighten:
- the nut on the positive terminal of the starter (8
Nm),
- the nut on the positive terminal of the starter (5
Nm).
a Connect:
- the Protection and Switching Unit connectors,
- the front left-hand wiring connectors,
- the diesel injection computer connectors,
- the refrigerant pressure sensor connector,
- the engine cooling fan assembly resistor connec-
tor,
- the engine cooling fan assembly connector,
- the air flowmeter connector,
- the exhaust gas temperature sensor connector,
- the exhaust gas recirculation solenoid valve con-
nector,
- the camshaft position sensor connector,
- the damper valve connector,
- the electric coolant pump connector,
- the reverse gear switch connector,
- the crankshaft position sensor connector,
- the coolant temperature sensor connector,
- the EGR cooler bypass control diaphragm solenoid
valve connector,
- the fuel rail pressure sensor connector,
- the turbocharging pressure regulation solenoid
valve connector,
- the turbocharger pressure sensor connector,
- all heater plug connectors,
JA5
K9K, and 772