Specifications

88A-50
WIRING HARNESS
Engine wiring: Removal - Refitting
K4J or K4M
88A
- the air temperature sensor connector,
- all coil connectors,
- the camshaft position sensor connector,
- the throttle valve connector,
- the air inlet pressure sensor connector,
- the camshaft dephaser solenoid valve connector,
- the fuel vapour absorber solenoid valve connector,
- the oil level sensor connector,
- the oil pressure sensor connector,
- the pinking sensor connector.
a Refit the alternator positive terminal nut.
a Torque tighten the alternator positive terminal nut
(24 Nm).
a Connect:
- the alternator exciter connector,
- the air conditioning compressor connector,
a Clip:
- the sub-frame and cylinder block wiring,
- the engine cooling fan assembly wiring,
- the intake manifold wiring.
III - FINAL OPERATION.
a Refit:
- the Protection and Switching Unit cover,
- the bolts on the Protection and Switching Unit cov-
er.
a Tighten the bolts on the Protection and Switching
Unit cover.
a Refit:
-the front bumper (see Front bumper: Removal -
Refitting) (MR 393, 55A, Exterior protection),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection),
- the battery tray (see 80A, Battery, Battery tray:
Removal - Refitting, page 80A-5) ,
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 392, 12A, Fuel mixture),
-the battery (see 80A, Battery, Battery: Removal -
Refitting, page 80A-1) ,
- the engine cover.