Specifications

88A-28
WIRING HARNESS
Front left-hand wiring: Removal - Refitting
RIGHT-HAND DRIVE
88A
a Disconnect the front left-hand wiring/rear left-hand
wiring connection (25) .
a Unclip the front left-hand wiring.
a Unclip the front left-hand wiring on the bulkhead.
a Remove the bonnet lock cable (see Bonnet lock:
Removal - Refitting) (MR 393, 52A, Non-side open-
ing element mechanisms).
a Remove the front left-hand wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a If replacing with more wiring, lock the unused con-
nectors (see Connectors: Sealing and immobili-
sation) (Technical Note 6015A, 88A, Wiring).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the front left-hand wiring,
- the bonnet lock cable (see Bonnet lock: Removal
- Refitting) (MR 393, 52A, Non-side opening ele-
ment mechanisms).
a Clip:
- the front left-hand wiring on the bulkhead,
- the front left-hand wiring.
a Connect the front left-hand wiring/rear left-hand wir-
ing connection.
a Clip:
- the dashboard cross member wiring,
- the windscreen washer fluid reservoir wiring,
- the front bumper upper cross member wiring,
- the bulkhead wiring.
a Clip the pedal wiring.
a Refit the windscreen wiper mechanism (see 85A,
Wiping - Washing, Windscreen wiper mecha-
nism: Removal - Refitting, page 85A-10) (MR 392,
85A, Wiping - Washing).
a Connect:
- the front left-hand wiring/dashboard wiring connec-
tion,
- the clutch pedal position sensor connectors,
- the brake light switch connector,
- the accelerator pedal potentiometer connector.
a Disconnect the front left-hand wheel speed sensor
connector.
a Refit the general earth wiring nut on the body.
a Torque tighten the earth cable nut on the body (8
Nm).
a Connect:
- the Protection and Switching Unit connectors,
- the brake fluid level sensor connector,
- the power supply fuse board connector,
- the battery protective fuse holder connectors.
a Refit the earth wiring nut to the brake hydraulic unit.
a Torque tighten the earth wiring nut to the brake
hydraulic unit (8 Nm).
C85
123676
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).