Specifications

88A-16
WIRING HARNESS
Front left-hand wiring: Removal - Refitting
LEFT-HAND DRIVE
88A
REMOVAL
REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equip-
ment).
a Switch off the ignition.
a Remove:
-the battery (see 80A, Battery, Battery: Removal -
Refitting, page 80A-1) ,
- the air filter unit (see Air filter unit: Removal - Re-
fitting) (MR 392, 12A, Fuel mixture),
- the battery tray (see 80A, Battery, Battery tray:
Removal - Refitting, page 80A-5) ,
- the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (MR 393, 55A, Exterior
protection),
- the front bumper (see Front bumper: Removal -
Refitting) (MR 393, 55A, Exterior protection).
a Remove the petrol injection computer (see Petrol
injection computer: Removal - Refitting) (MR
392, 17B, Petrol injection).
a Remove the diesel injection computer (see Diesel
injection computer: Removal - Refitting) (MR
392, 13B, Diesel injection).
a Remove:
- the injection computer mounting,
- the front door sill lining (see Front door sill lining:
Removal - Refitting) (MR 393, 71A, Body internal
trim).
a Remove the dashboard side face (1) .
Tightening torquesm
earth cable nut on the
body
8 Nm
earth wiring nut to the
brake hydraulic unit
8 Nm
earth wiring nut on the
front left-hand side
member
8 Nm.
earth wiring nut on the
front right-hand side
member
8 Nm.
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precau-
tions for the repair, page 88A-5) .
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.
Note:
It is not necessary to remove the dashboard to
access the pedal wiring.
D4F or F4R or K4J or K4M or M4R
K9K
112379