Specifications

88A-9
WIRING HARNESS
Front bumper wiring: Removal - Refitting
FOG LIGHTS
88A
a Disconnect the (2) fog light connector (1) .
a Mark the routing of the wiring in the front bumper.
a Unclip the front bumper wiring (3) .
a Remove the wiring.
REFITTING
I - REFITTING PREPARATION OPERATION
a If replacing with more wiring, lock the unused con-
nectors (see Connectors: Sealing and immobili-
sation) (Technical Note 6015A, 88A, Wiring).
II - REFITTING OPERATION FOR PART
CONCERNED
a Reconnect the fog light connector.
a Clip the wiring onto the front bumper in the position
marked during the removal operation.
III - FINAL OPERATION.
a refit:
- the front bumper (see Front bumper: Removal -
Refitting) (MR 393, 55A, Exterior protection),
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-1) .
a Check the operation of the fog lights.
116848
WARNING
To prevent any damage during the removal oper-
ation, check that the wiring is free from its mount-
ings (retaining clip, plastic clip, adhesive tape,
connector, etc.).
WARNING
To prevent damage to the wiring harness when
refitting, observe the original routing.