Specifications

88A-8
WIRING HARNESS
Front bumper wiring: Removal - Refitting
FOG LIGHTS
88A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equip-
ment).
a Switch off the ignition.
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-1) .
a Remove:
- the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting) (MR
393, 55A, Exterior protection),
- the front bumper (see Front bumper: Removal -
Refitting) (MR 393, 55A, Exterior protection).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 88A, Wiring harness, Wiring: Precau-
tions for the repair, page 88A-5) .
123661
WARNING
To prevent any risk of noise, premature wear,
short circuits, etc. after the refitting operation,
mark the wiring routing and how to connect the
connectors.