Specifications

88A-1
WIRING HARNESS
Headlining wiring: Removal - Refitting
88A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Depending on the equipment level of the vehicle, re-
move the covers for the interior rear-view mirror in
order to disconnect the rain sensor connector (see
85A, Wiping - Washing, Rain and light sensor:
Removal - Refitting, page 85A-5) .
a Remove the headlining (see Headlining: Removal -
Refitting) (MR 393, 71A, Body internal trim).
a Gently disconnect the wiring harness connector.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Mark out the routing of the wiring harness.
a Gently detach the wiring harness.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
a Use a pasting nozzle to refit the wiring harness.
a Paste the wiring harness onto the routing that was
marked out.
a Cut the bead, taking care not to damage the wiring
harness.
II - FINAL OPERATION.
a Refit the headlining (see Headlining: Removal -
Refitting) (MR 393, 71A, Body internal trim).
a Depending on the level of equipment of the vehicle,
reconnect the rain sensor connector.
a Depending on the equipment level of the vehicle, re-
fit the interior rear-view mirror covers (see 85A, Wip-
ing - Washing, Rain and light sensor: Removal -
Refitting, page 85A-5) .
112590
112885
Note:
It is possible to replace the headlining and keep
the wiring harness, and vice-versa.
The wiring harness cannot be repaired. It must
be replaced if it is cut, broken or burnt.
WARNING
The position of the connectors in relation to the
side of the headlining must be respected. A mark
on the harness must coincide with the edge of
the headlining.
Note:
It is also possible to leave the faulty harness in
place, and to glue the new harness alongside it.