Specifications

87G-1
ENGINE COMPARTMENT CONNECTION UNIT
Protection and Switching Unit: Removal - Refitting
87G
REMOVAL
I - REMOVAL PREPARATION OPERATION
a In the event of replacement:
- Carry out the necessary programming (see MR
394 Fault finding, 87G, Engine compartment
connection unit, Fault finding - Replacement of
components).
a Remove the battery tray (see 80A, Battery, Battery
tray: Removal - Refitting, page 80A-5)
II - REMOVAL STAGE FOR THE PART
CONCERNED
a Remove:
- the bolts (1) from the engine compartment connec-
tion unit cover,
- the cover.
a Unclip each Protection and Switching Unit connector
by pressing the connector retaining lug, without ap-
plying any pressure to the unit joint face.
Special tooling required
Car. 1597 Trim removal lever.
Tightening torquesm
engine compartment
connection unit bolts
4 Nm
engine compartment
connection unit cover
bolts
4 Nm
IMPORTANT
Never apply pressure to the engine compartment
connection unit joint face (risk of moisture entering).
If the joint face is damaged, the unit will need to be
replaced.
112213
112212