Specifications

87C-9
OPENING ELEMENT MANAGEMENT
Opening aerial: Removal - Refitting
VEHICLE WITH CARD
87C
REMOVAL
I - REMOVAL PREPARATION OPERATION
1 - Opening aerials integrated in the door handles
a Remove the door handle (see Exterior door han-
dle: Removal - Refitting) (MR 393, 51A, Side open-
ing element mechanisms).
2 - Opening receiver integrated in the rear bumper
a Remove the rear bumper (see Rear bumper: Re-
moval - Refitting) (MR 393, 55A, Exterior protec-
tion).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Opening aerials integrated in the door handles
a The handle - aerial - presence and movement sen-
sor assembly cannot be dismantled.
2 - Opening receiver integrated in the rear bumper
a Unclip the aerial by pushing the clips (1) .
a Disconnect the connector.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
1 - Opening aerials integrated in the door handles
a Refit the door handle (see Exterior door handle:
Removal - Refitting) (MR 393, 51A, Side opening
element mechanisms).
2 - Opening receiver integrated in the rear bumper
a Connect the connector.
a Clip the aerial onto the bumper.
a Refit the rear bumper (see Rear bumper: Removal
- Refitting) (MR 393, 55A, Exterior protection).
101931
113333