Specifications

84A-6
CONTROL - SIGNALS
Steering column switch assembly: Removal - Refitting
84A
a Undo the rotary switch mounting bolt (6) .
a Press down on (7) using a flat-blade screwdriver to
release the rotary switch.
a Remove part of the steering column controls assem-
bly to disconnect the connectors.
a Remove the steering wheel control assembly.
REFITTING
I - REFITTING PREPARATION OPERATION
a
a
a Position the wiring harness as indicated (8) .
II - REFITTING OPERATION FOR PART
CONCERNED
a Connect the connectors.
a Position the steering column controls assembly.
a Fix the steering column controls assembly into
place.
III - FINAL OPERATION
a Refit the steering column half-covers.
a Fix the half-covers into place.
a Refit the steering column trim.
a Fix the steering column trim.
a Clip the protective strip into place.
107709
WARNING
Make sure that the wheels are set straight ahead
and that the rotary switch mark is at 0.
107718
WARNING
It is essential to observe the wiring harness rout-
ing to prevent it being damaged when the half-
shells are refitted.