Owner Manual

OPERATING YOUR APPLIANCE
It is recommended that you install the appliance in a place where the ambient
temperature is between 50°F and 109.4°F (10°C-43°C). If the ambient temperature is
above or below recommended temperatures, the performance of the unit may be
affected. For example, placing your unit in extremely cold or hot conditions may cause
interior temperatures to fluctuate. The operating temperature range may not be reached.
C
F
SET
C
F
CONTROL PANEL
ON/OFF Power
To turn the appliance ON or OFF, press and hold the POWER key for 5 seconds.
UP and DOWN
Press first, then press or button to increase (warm) or decrease (cool) the set temperature
by 1°C/1°F.
Press again, the temperature is selected and shows the actual temperature. If no other further
operation in 6 seconds, display will show actual temperature in the cooler.
°C/°F Selector
Selects the temperature display setting in Fahrenheit or Celsius degrees. To change the
temperature from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and at the same
time, then hold for 6 seconds.
Setting the Temperature Control
The temperature you are setting will increase by one degree each time you press the key, and
will decrease by one degree each time you press the key.
The range of the temperature control is from 23°F to 68°F.
To view the set temperature at any time, press the key. The set temperature will flash in the
display window for 6 seconds. After 6 seconds, the temperature inside the unit will reappear in the
display window.
(The temperature preset at the factory is 39°F).
SET
SET
SET
SET
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the drawer, if it not already attached (See page 7).
INSTALLATION OF YOUR APPLIANCE
Your outdoor two drawer refrigerator has been designed for both built-in and free standing. When
built-in, your refrigerator drawers do not require additional air space for top, side or rear. The front
grille must NOT be obstructed.
Note: It is recommended that you do not install the appliance near an oven, radiator or other heating
source, as heat sources may increase electrical consumption. Do not install in a location where the
temperature will fall below 50°F (10°C). For best performance, do not install the appliance behind a
cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly grounded wall outlet.
SITE PREPARATION
1. Position the unit on a flat, level surface capable of supporting the entire weight of the unit.
Remember the unit will be significantly heavier once it is fully loaded.
2. Connect the unit to a Ground Fault Interrupter (GFI).
3. The unit must be installed according to your local codes and ordinances.
4. ELECTROCUTION HAZARD!
Electrical Grounding Required- This appliance is equipped with a three prong
(grounding) polarized plug for your protection against possible shock hazards.
NEVER remove the round grounding prong from the plug.
NEVER use a two-prong grounding adapter.
NEVER use an extension cord to connect power to the unit.
Where a two-prong wall receptacle is encountered or a longer power cord is
required, contact a qualified electrician to have it replaced in accordance with
applicable electrical codes.
!
8 5