Owner Manual

TABLE OF CONTENTS
Appliance Safety
Important Safeguards
Installation Instructions
Before Using Your Appliance
Installation of Your Appliance
Site Preparation
Anti-tip Bracket Installation
Leveling the Unit
Installing Handle
Electrical Connection
Extension Cord
Operation Your Appliance
Control Panel
Defrosting
Temperature Alarm / Drawer Alarm
Removing your Appliance
Care and Maintenance
Cleaning and Maintaining Your Appliance
Power Failure
Vacation Time
Moving Your Appliance
Energy Saving Tips
Troubleshooting
3
3-4
5-7
5
5-6
6
6
7
7
7
7
8-9
8-9
9
9
9
9-10
9
10
10
10
10
11-12
TROUBLESHOOTING
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM POSSIBLE CAUSE REMEDY
Appliance
does not
operate.
Appliance is
not cold
enough.
Appliance
turns itself on
and off
frequently.
The light does
not work.
Vibrations
The appliance
seems to
make too
much noise.
The drawer will
not close
properly.
Appliance is not connected to a power supply.
The appliance is turned off.
Tripped circuit breaker or blown a fuse.
The temperature is not set correctly.
Temperature could require a lower
temperature setting.
The drawer was not closed completely.
Drawer is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too dusty.
The room temperature is higher than average.
A large amount of food has been added
to the unit.
The drawer is open too often.
The drawer is not closed completely.
The drawer gasket does not seal properly.
Appliance is not connected to a power supply.
Tripped circuit break or blown a fuse.
The light was switched off on the control panel.
The appliance is not properly leveled.
The rattling may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and cracking noises.
The appliance is not properly level.
The appliance is not properly level.
The drawer was reversed and not properly
installed.
The gasket is dirty.
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace fuse.
Check the set temperature.
Set a lower temperature.
Do not open the drawer more
often than necessary.
Close drawer properly.
Check the drawer seal and clean/replace.
Clean the condenser when necessary.
Clear the obstructions, clean the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open more than necessary.
Close drawer properly.
Check the drawer seal and clean/replace.
Connect the appliance.
Switch on circuit breaker or replace fuse.
Switch on the light.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Level the appliance with the
adjustable feet.
Check the drawer hinge and reassemble
correctly.
Clean the drawer gasket.
2 11