User's Manual Part 1

Starting AccelTest
19
Starting
AccelTest
Student Instructions for Using AccelScan
1.Be sure that you filled in your three-digit Student ID number and Assignment ID number (and letter, if used)
at the top of the scan card. Fill in a bubble underneath each number (or letter).
2.Check over your AccelScan scan card.
*Make sure that all answers have been filled in and marked next to the correct problem numbers.
*Erase any stray marks.
*If any answers were changed, be sure the old answers are completely erased.
3.The Score Assignments screen
shows that the scanner is ready.
4.Insert the scan card into the scanner
face up, with the scan card number
and arrow going into the scanner first.
5.The scanner will take the scan card
and score the assignment. The
message saying the scanner is ready
will appear again. If AccelScan cannot
read your scan card a message will
tell you to see your teacher.
6.Your card will be behind the
scanner. Save it so you can use the
other side.
Fill in the Assignment ID numbers
(and letter, if used).
Fill in the bubbles under each digit
(or letter, if used).
Fill in the Student ID numbers.
Fill in the bubbles under each digit.