User's Manual

TROUBLESHOOTING
Reinstalling or Repairing Keys on the NEO Keyboard
225
. . . . .
NEO
User Manual
Reinstalling the Scissors Assembly
1. If one or both of the white scissors assembly pieces are still attached to
the key cap, separate them from the key cap.
2. Now, place the two scissors pieces in front of you, so that the square
piece is on your left and the round piece is on your right as shown. (There
are two types of round assemblies, both of which are shown. You may
have either type.)
Make sure the pieces have the correct sides facing up; the square piece
should be tilted slightly towards the right, and the round piece should tilt
slightly towards the left.
3. Now, slide the round piece underneath the square piece, and bring it up
through the center of the square piece. Halfway up, maneuver the small
knobs on each side of the round piece into the holes on each side of the
square piece, one at a time, to create the scissoring action. When you’ve
finished, the assembly should look like the second picture below.