Troubleshooting guide

APPENDICES

118

Driver Properties Printing Adjustments - Quick Reference

These features are located under the Layout tab of the M-Series Driver (R12.01)

Left Adjustment

Range: -30 (-3mm) left to 2000 (+200mm) right. Default = 0

- Moves the image area, left or right on the media.

Top Adjustment

Range: -50 (-5mm) up to 2000 (+200mm) down. Default = 0

- Moves the image up or down on the media.

Max Page Width

Range: 5 (0.5mm) to 2208 (220.8mm). Default = 2208 (max print width of printer)

– Lets you set how wide the actual print area will be. Reducing this value from 2208 will reduce

the max print width of the printer.

Purge Bar Position*

Range: -538 (-53.8mm) up to 2000 (+200mm) down. Default = 0

– Allows you to adjust the purge bar location; to account for the extra length needed to reach the

actual gap between pieces.

Tip: Set value so purge bar is positioned about 3 mm past the trailing edge of the media.

* See also “Purge Bar Position” in the “Using the Toolbox Utility” section.

1=0.1mm, 10=1mm