Troubleshooting guide

SECTION 5
MAINTENANCE
72
Installing the Service Station
CAUTION
THIS PROCESS MUST BE PERFORMED BY A
QUALIFIED TECHNICAL SUPPORT PERSON.
Due to the technical nature of this procedure; this process should only be performed by a qualified technical
support person. This process is normally performed when the printer is first installed or when technical
maintenance is needed on the printer.
The Service Station fits in the slot immediately above the Ink Tank slots.
PROCEDURE:
1. Make sure the printer is powered OFF.
If the printer is not
powered off, press the ON/OFF button once and wait about 45 seconds for the print
engine to power off (all control panel light’s off). Then turn the Main Power Switch OFF.
2. Open the Ink Tank Door (hinged at bottom).
3. Open the Top Cover.
4. Remove the Exit Roller Cover by removing the four (4) screws.
The Service Station Slot and Ribbon Cable will be exposed.
5. If you are installing a New Service Station; carefully remove the Service Station from its packaging.
NOTE: Loose parts may fall out. Keep wiper roller side facing up, when removing the packaging.
6. Check to be sure that the wiper roller latches are secure.
CAUTION!
Make sure latches on the Wiper Roller are fully latched before installing the Service Station.
New Service Stations have screws that secure the latches from opening in transit or use.
Check the latch at each end of
the wiper roller.
Ribbon
Cable
Service Station
Slot
Ink Tank
Door