Troubleshooting guide

SECTION 4
SOFTWARE SETUP INFORMATION
61
Envelope #10 (9.5” wide x 4.13” long) feeding flap first:
Valid when using Microsoft Word
®
2007 and the M Series Driver version R9.1.
The following procedure assumes that the printer has been setup to feed # 10 envelopes, flap first and that
you are using Windows 7.
Don’t forget to position the “Media Registration Side Guide” to the outer position.
NOTICE! During this process we found that MS-Word 2007 would over-ride our settings; making this
setup process very frustrating. Therefore we recommend using Satori Bulk Mailer as a better alternative.
NOTE: When feeding a #10 envelope in this
orientation you cannot
print the entire width of
the envelope. Since the printer’s maximum print
width is 8.5”; the document size in MS Word will
be set to 8.5” W x 4.13” H and the orientation
will be set to Portrait.
1. Click on the Start icon, and then select “Devices
and Printers”.
2. Right-Click on M Series Driver and select
“Printing preferences”.
The “M Series Driver Printing Preferences”
window will open.
3. On the “General” Tab, under “Orientation,” click on
Portrait.
Then under “Media”, “Size:”, click on the “Custom
Sizes” button.
The “Custom Media Size” window will open.
4. In the “Media Name:” area; type a custom name.
Example: “#10 Flap First”
5. Set the Size to:
Width: 8.50”
Height: 4.20”
Tip: If you set height to 4.13” it will default
to 4.20”.
6. Click on Save.
Then Click on OK to close the “Custom
Media Size” window.
7. Click on OK to close the “M Series Driver
Printing Preferences” window.