Troubleshooting guide

SECTION 3
OPERATING THE PRINTER
35
Printer Status Light Indicator Chart (continued) (see legend)
Valid with Firmware 110928_u or higher installed.
ON/OFF
PAPER
RESUME
PAUSE
CANCEL
Printer Status
corresponding Toolbox message
Additional Details, Possible Solution or Action

ON
/ fast / fast
Tilt Error
Toolbox = TILT_ERROR
Verify that printer is on a sturdy, level table (front to back and
left to right). Level the table, NOT the printer body. Do NOT
use the printer’s tilt values to level the printer or table. Use an
18” or longer carpenters level to level the table.
WARNING: If the printer is not placed on a sturdy level table,
damage to the printer may result.
If just powered on, wait a few minutes; tilt readings may settle
into normal range.
Once tilt readings drop into a normal range (tilt values are no
longer RED) the error can be cleared using the “Clear Error”
feature in the Toolbox.
If problem persists; please call for Service.
Please see the “Toolbox System Status Messages” section for more details on Toolbox messages.
Alternating Fast Flash
(3/sec)